The Isolation Adapter is an optional accessory which provides electrical isolation between the target system and the ULINKpro debug and trace unit. Electrical isolation is essential when working with systems that may generate high-voltage spikes such as motor control, or where there is no common ground plane. The Isolation Adapter uses digital isolation technology which enables it to support high-speed debug and trace as well as a wide target voltage range.
Provides digital isolation up to 1,000V (1KV)
High-speed Debug - JTAG (15MHz) and SW (20MHz)
Full-speed data trace capture (SWV)
Supports instruction trace capture up to 150 Mbps using 2 or 4-pin ETM
Enables timing synchronization with optional power measurement probes
Wide I/O Voltage range 1.8V - 5.5V
External power (via USB connector) minimizes power taken from target
10-pin Cortex debug (0.05 inch connector)
20-pin Cortex debug + ETM Trace (0.05 inch connector)
The Isolation Adapter replaces ULINKpro's standard 20-pin ribbon cable, and connects to either the 10-pin (Cortex Debug) or 20-pin (Cortex Debug + ETM) connectors on Keil evaluation boards.
The Isolation Adapter is not included as standard with ULINKpro. It must be purchased separately.
The Isolation Adapter is not suitable to use with ULINK-ME, ULINK2, or the original ULINK adapter.
We may collect and store information about your visit to our web site automatically using browser cookies (files which are sent by us to your computer) or similar devices which we can access when you visit our web site in future.
You can control the cookies set by this website by using the slider below, and by saving your settings.
These settings only apply to the ARM Website you are currently visiting and any changes you make will not apply to any other ARM websites.
We cannot turn off cookies which fall under the strictly necessary category, as these are essential in order to enable you to move around the website and use its features.
These cookies are likely to be performance cookies or targeting cookies.