*
*Home|Chinese|Japanese*About ARM|Forums|Events|News|Employment|Contact Us|Investors*
dotted rule
*ARM - the architecture for the digital worldARM - the architecture for the digital world
search
*
*
***
*MARKETS:PRODUCTS & SOLUTIONS:CONNECTED COMMUNITY:TECHNICAL SUPPORT:DOCUMENTATION*
*
technical support
*Home > Technical Support > FAQs > IP FAQs > General: What default state sh...
*
****
*.Technical Support
*
*
*>>Home Page*
*
*.Obtaining Support*
*
*.FAQs*
*
**Development Tool FAQs*
**IP FAQs*
**Embedded Software FAQs*
**Artisan Physical IP FAQs (Login Required)*
*
*.Downloads*
*
*.Documentation*
*
*.Training*
*
*.Where To Buy*
*
*.Keil MCU Tools*
*
*.What's New*
*
*.ARM Newsgroups*
*
*.Active Assist On-site Services*
*
*
*
technical support FAQsask ARM*
*

Technical Support Search
*     (Advanced Search)
  FAQs   Documentation   Downloads   Forums

*

downarrowGeneral: What default state should be used for the HREADY and HRESP outputs from a slave?

Applies to:AMBA AHB

It is recommended that the default value for HREADY is high and the default value for HRESP is OKAY. This combination ensures that the slave will respond correctly to IDLE transfers to the slave, even if the slave is in some form of power saving mode.

See also:






back to top
*
**
*4 dots*Other ARM Websites
*
shadow *LEGAL STATEMENTshadow