*
*Home|Chinese|Japanese*About ARM|Forums|Events|News|Employment|Contact Us|Investors*
dotted rule
*ARM - the architecture for the digital worldARM - the architecture for the digital world
search
*
*
***
*MARKETS:PRODUCTS & SOLUTIONS:CONNECTED COMMUNITY:TECHNICAL SUPPORT:DOCUMENTATION*
*
technical support
*Home > Technical Support > FAQs > Development Tool FAQs > Why does RVIUpdate fail to update my RealView-ICE firmware?
*
****
*.Technical Support
*
*
*>>Home Page*
*
*.Obtaining Support*
*
*.FAQs*
*
**Development Tool FAQs*
**IP FAQs*
**Embedded Software FAQs*
**Artisan Physical IP FAQs (Login Required)*
*
*.Downloads*
*
*.Documentation*
*
*.Training*
*
*.Where To Buy*
*
*.Keil MCU Tools*
*
*.What's New*
*
*.ARM Newsgroups*
*
*.Active Assist On-site Services*
*
*
*
technical support FAQsask ARM*
*

Technical Support Search
*     (Advanced Search)
  FAQs   Documentation   Downloads   Forums

*

 
downarrowWhy does RVIUpdate fail to update my RealView-ICE firmware?
Applies to: Installer, RealView ICE (RVI)

The RealView ICE Update utility, supplied with RVI v3.1 or v3.2 host software, will fail to update older versions of firmware on an RVI unit. An attempt to update from firmware v1.5 (or earlier) will fail with the following message: 'An error has occurred while writing to the RealView ICE'.

To correct this problem please install the RealView-ICE v3.1.3 or RealView-ICE v3.2.1 patch. It should now be possible to update your firmware without error.

If you attempted to update your RealView-ICE to v1.7 firmware using v3.1 or v3.2 host software, and the unit no longer boots using Ethernet or USB (all LEDs are off), please contact ARM support (support-sw@arm.com) for further instruction.



Related:






back to top

*
**
*4 dots*Other ARM Websites
*
shadow *LEGAL STATEMENTshadow